6
Operating instructions
1. Press
for longer than 2 seconds to turn the device on.
The unit will begin a self-test.
If the self-test is unsuccessful see the trouble shooting instructions on page
26 in the Operators guide.
During set up you can conrm or cancel your decisions using the three
buttons at the side of the screen.
2. Verify if the PSU
™
is connected to a new patient.
THIS INFORMATION IS IMPORTANT FOR
THE DATA READING & RECORDING.
YES – New patient number is issued.
NO – Patient number is unchanged:
Recommended for continued treatment of the same patient.
Data recording is continued.
Setting
Decision
Buttons
To Next Page
Loading...