11
RF-AHD25
Note: Some motherboards do not support eSATA hot-plug
and play function. If your motherboard does not, follow
these steps to set up your RF-AHD25:
1. Shut down your computer.
2. Turn on your RF-AHD25, then connect it to your computer.
3. Power on your computer.
Notes:
Windows 2000/XP/Vista/7
No drivers are necessary when using Windows
XP/2000/Vista. If the hard drive does not appear in My
Computer, be sure to partition your hard drive.
Mac OS X 10.3 or higher
No drivers are necessary when using Mac OS X 10.3 or
higher. If the hard drive does not appear on the desktop, be
sure to partition your hard drive.
Disconnecting the enclosure from your
computer
To disconnect the enclosure from your Windows computer without
shutting it down:
Note: If a drive window is open or the hard drive enclosure
is active, close any associated windows before attempting
to remove the enclosure.
1 Left-click the Hot plug icon (located in the notification
area of taskbar where your usually see the time
displayed).
2 Select the drive you want to unplug, then click STOP.
3 When Windows notifies you that it is safe to do so,
unplug the enclosure from your computer.
09-0772 RF-AHD25_MAN_ENG_V3.fm Page 11 Monday, October 12, 2009 10:55 AM
To Next Page
Loading...
Need help?
General
