10
Connecting the enclosure to your computer
Before connecting your external storage enclosure:
• Confirm that your system supports SATA. If your system
does not support SATA, please install an eSATA host card.
• Confirm that the eSATA port on your system is working
properly. If not, please refer to your computer
manufacturer for assistance in getting the eSATA port to
work properly.
• To enable auto mount for SATA, your system must
support Plug and Play.
Notes:
Connect the enclosure with to your computer, either
through a USB or eSATA connection. If you are using an
eSATA connection, the AC adapter is required.
The enclosure provides USB and eSATA dual interface for
host connectivity. The high-speed eSATA port has priority
over the USB port when both are connected at the same
time.
Important: For new hard drives, you need to initialize and
partition your hard drive before it will appear in Windows
Explorer or on your Mac desktop. Please refer to your hard
drive manufacturer’s documentation or read “ Creating A
New Partition” section of this manual on page 20.
To connect the enclosure to your computer:
1 Plug one end of a USB 2.0 cable or eSATA cable to the
enclosure, then plug the other end of the cable to your
computer.
2 Plug one end of the power adapter into the enclosure,
then plug the other end to an AC outlet if you are using
eSATA mode.
The operating system automatically detects and sets up
the new drive.
09-0772 RF-AHD25_MAN_ENG_V3.fm Page 10 Monday, October 12, 2009 10:55 AM
To Next Page
Loading...
