8
Setting up your receiver connection
When used for the first time, the Rocketfish Miracast Video Receiver
starts in Auto mode and is ready to accept a Wi-Fi direct connection.
To set up your receiver connection:
1 Make sure that the TV or projector screen shows the Rocketfish
Miracast Video Receiver screen.
2 On your Miracast mobile device, such as a smartphone or tablet,
turn on the Wi-Fi network.
3 On your Miracast mobile device, select the SSID (network name)
that is displayed on your TV. See the documentation that came
with your Miracast mobile device to complete the setup.
4 Press the WPS button on the Rocketfish Miracast Video Receiver.
The blue LED will start to blink while the receiver searches for a
connection.
5 When the connection is successful, your Miracast mobile device's
screen is displayed on your TV, indicating that video streaming
has started.
Note: To re-connect a device that has been previously connected, repeat steps 1-5.
12-1245_RF-WFD301_MAN_V1_EN.fm Page 8 Tuesday, June 4, 2013 10:36 AM
To Next Page
Loading...
Need help?
General
