19RF-WHP01/WHP02
To charge the headphones:
• Place the headphones onto the docking station cradles, and make sure
the headphone charging contacts and the docking station charging pins
make contact.
• The docking station charging indicator glows red to indicate the
headphones are charging.
• When the headphones are fully charged (which takes approximately
five hours), the docking station charging indicator turns green.
Note: It can take about five hours to charge the batteries. The batteries will last up to
15 hours (WHP02) or 8 hours (WHP01) with continuous use.
Note: The headphones can be charged whenever the docking station and
headphone power slide switches are set to on or off.
Establishing a link between the headphones and the
docking station
To establish a link between the headphones and the docking station:
1 Set the POWER ON/OFF switch located on the headphones’ left
earpiece to ON.
Notes:
• If the headphone power is low, the indicator glows red. Charge the
headphones. For charging details, see “Charging the headphones” on
page 18.
L
R
08-1077 RF-WHP01-WHP02.book Page 19 Thursday, March 27, 2008 1:29 PM
To Next Page
Loading...
Need help?
General
