Need help?Do you have a question about the Rockford Fosgate R600-4D and is the answer not in the manual?
General| Brand | Rockford Fosgate |
|---|---|
| Model | R600-4D |
| Category | Amplifier |
| Language | English |
Congratulates the customer and highlights the product's quality and engineering.
Provides essential safety precautions for using the amplifier, including hearing protection.
Briefly mentions the product's design expertise and recommended installation.
Recommends professional installation and using authentic accessories for best performance.
Welcomes the user and explains the manual's purpose and potential for changes.
Details critical warnings and cautions for installation and operation to prevent injury.
Lists the items included with the amplifier, such as the manual and hardware kit.
Explains the function of the Power LED (blue) and Protect LED (red) indicators.
Describes the RCA input jacks for signal and pass-thru jacks for daisy-chaining.
Details Gain Control, Crossover Switch, Variable Crossover, and Punch EQ.
Explains the 2/4 Channel Switch and describes Speaker, Power, and REM terminals.
Lists tools needed and provides pre-planning advice for system layout and wiring routes.
Provides guidance on selecting appropriate mounting locations, warning against engine compartments.
Details mounting requirements in the passenger compartment for adequate cooling.
Recommends checking vehicle's battery and charging system for amplifier load.
Provides step-by-step instructions for routing and connecting power, ground, and remote wires.
Details connecting RCA cables to inputs and speaker wires to terminals, noting polarity.
Emphasizes final connection checks and warns against low impedance bridged loads.
Guides on setting the amplifier's input gain control for optimal volume and minimal distortion.
Explains setting the crossover for High Pass, All Pass, and Low Pass modes (50-250Hz).
Details how the 2/4 Channel switch affects input connections and output behavior.
Describes the Punch EQ feature for variable bass boost adjustment with a caution.
Checks power, fuses, ground, and voltage for correct amplifier connections.
Diagnoses issues when the Protect light is illuminated, checking speaker connections.
Verifies RCA input connections, cable integrity, and signal presence for audio output.
Provides solutions for turn-on pop noise, suggesting delay modules or alternative power sources.
Offers methods to resolve engine noise interference by managing wiring and grounding.
Lists RMS power output for R400-4D and R600-4D at various impedance loads.
Provides height, width, and length measurements for the amplifier models.
Specifies battery fuse rating and CEA-2006 weighted signal-to-noise ratios.
Details crossover slope, frequency range, and amplifier frequency response.
Covers signal voltage range, protection features, Punch EQ, and input impedance.
Lists operating voltage, balanced inputs, damping factor, and THD+N.
Outlines warranty periods for amplifiers and details what is covered and who is covered.
Lists conditions and damages that are not covered by the product warranty.
Provides instructions for obtaining service and mentions EU warranty requirements.
To Next Page