Need help?Do you have a question about the Rockford Fosgate TM400X2ad and is the answer not in the manual?
General| Number of Channels | 2 |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| Total Harmonic Distortion (THD) | < 1.0 % |
| Speaker Output Impedance | 2 Ohm / 4 Ohm |
| Crossover | 12dB/Octave |
Guidelines for safe listening to prevent hearing loss from high sound pressure levels.
Alerts users to important instructions, failure to heed may result in severe injury or death.
Alerts users to important instructions, failure to heed may result in injury or unit damage.
Disconnect battery, ensure professional installation if unsure, and follow manual instructions.
Indicator that lights red when audio source reaches its clipping point.
Control used to match the output of the audio source.
Gyrator-based EQ that boosts frequency shift with boost.
Built-in 12dB/octave Butterworth filter with adjustable crossover point.
Allows remote control of the amplifier's output level.
Selectable switch for High-Pass (HP), All Pass (AP), or Low-Pass (LP).
Activates the use of an optional remote Punch Level Controller.
RCA inputs accept high-level (speaker) or low-level (RCA) signals; enables auto turn-on.
Indicator that illuminates based on audio content to show clipping.
Switch to select 2-channel or 4-channel mode, or subwoofer input.
Fixed 28Hz filter to prevent low frequencies from reaching the subwoofer.
Indicates power status (blue), short circuit/impedance (yellow), or overheat (red).
Details on Molex and nickel-plated quick connect speaker terminals.
Terminals for power, ground, and remote turn-on connections.
Vehicle-specific considerations for amplifier installation.
Guidelines for optimal amplifier placement and heat dissipation.
Specific recommendations for mounting amplifiers on ATVs, Golf Carts, or Motorcycles.
Ensures adequate capacity for amplifier load.
Connecting the power wire with proper fusing and routing.
Securing a clean, short ground connection to the chassis.
Connecting the remote wire to turn the amplifier on/off.
Connecting RCA inputs and speaker wires with correct polarity.
Step-by-step guide to setting the input clip indicator for optimal audio levels.
Guide to setting the output clip indicator for channel levels of input.
How to set the crossover point for High Pass, All Pass, and Low Pass modes.
Setting the switch for 2-channel or 4-channel input modes.
Connecting speaker-level signals and activating the auto turn-on feature.
Adjusting bass, mid-bass, and treble boost according to crossover setting.
How to install and use the optional remote control for subwoofer level.
Verifying power, ground, and remote connections are secure and functional.
Diagnosing and resolving issues causing the protect light to illuminate.
Troubleshooting lack of audio output, checking RCA connections and inputs.
Resolving audio pops when turning the amplifier on or off.
Eliminating engine noise by proper wire routing and grounding.
Troubleshooting issues with the remote turn-on function.
Diagnosing problems with the remote control's indicator lights.
Details the warranty period for different Rockford Fosgate product types.
Specifies what aspects of the product are covered under the warranty.
Lists damages or conditions that void the product warranty.
Explains limitations on implied warranties like fitness for use and merchantability.
Provides instructions and contact information for obtaining warranty service.
To Next Page