The dead man’s switch alert allows you to set a frequency. You are then required to press a button on
the device at least every X minutes, to confirm you are still with the device. The timer resets every
time a button is pressed.
!
If a button is not pressed at least every X minutes, or when prompted then an automatic alert is sent.
!
Temperature Alert
!
Should the temperature leave your defined range (e.g. 0 degrees to 40 degrees) then an automatic
alert will be sent. This option allows you to turn this alert type on/off and set the temperature over
which the alert will be sent.
!
Power Loss Alert
!
If this option is turned on, should the unit lose external power then an automatic alert will be sent.
!
Bluetooth Pairing Loss Alert
!
If this option is turned on, should the unit lose its pairing with a Bluetooth device then an automatic
alert will be sent
!
Geo-fence Alert
!
This alert type allows you to set your current position, then set a distance. Should the device leave
the pre-defined circular area, an automatic alert will be sent.
!
Collision Alert
!
This alert is somewhat experimental in nature, as a ‘collision’ can vary in force and strength, and so
every situation is different. This alert can be used to notify you of a given shock being applied to the
device. There is a ‘threshold’ and a ‘duration’ setting. The threshold sets how many G-forces will set
off the alert, and the duration sets how long that force needs to be constantly applied for, before the
alert is set.
!
At its lowest settings, the alert will detect a simple ‘tap’ on the device. At the highest settings, it will
not send an alert until a very strong impact is detected.
!
We suggest you experiment with the settings, if this is of interest, to find what works in your
particular situation.
!
!
Settings Menu
!
Screen idle
!
After a set number of seconds the screen will timeout to save battery. This option allows you to set
the number of seconds before this happens.
!
Screen lock
!
You must first enter the current PIN number for the device to access this menu. The default PIN is
1234. In this menu you can turn on/off the screen lock and set a PIN code to access the device. When
this option is turned on, you must enter a PIN code to be able to access the menu system.
!
To Next Page
Loading...