FLEX I/O Digital DC Output Modules 5
Publication 1794-IN094D-EN-P - July 2018
WARNING: When you insert or remove the module while backplane power
is on, an electric arc can occur. This could cause an explosion in hazardous
location installations.
Be sure that power is removed or the area is nonhazardous before
proceeding. Repeated electric arcing causes excessive wear to contacts on
both the module and its mating connector. Worn contacts may create
electrical resistance that can affect module operation.
WARNING: If you insert or remove the module while backplane power is on,
an electric arc can occur. This could cause an explosion in hazardous location
installations.
Be sure that power is removed or the area is nonhazardous before
proceeding.
At the end of its life, this equipment should be collected separately from any
unsorted municipal waste.
To Next Page
Loading...
Need help?
General
