ROEL Cerber C41V4 - Page 3

Cerber
®
C41V1/Cerber
®
C41V4
HOOKUP INSTALLATION & PROGRAMMING BOOK
3
INTRODUCTION
Cerber C41V1/Cerber C41V4 are keypad operated burglary systems, with
built-in telephone dialer, alarm memory and 4 access codes.
Only one 30 second vocal message is available for Cerber C41V1 control
panel.
Four vocal messages, approx. 15 seconds each, are available for Cerber
C41V4 control panel.
The system facilities are keypad programmable. The central unit is RISC
microprocessor designed. The electric scheme includes an EEPROM
memory. Thus, the programmed parameters are retained even after all power
was removed from the control panel.
FEATURES:
 4 End-of-Line Resistor supervised zones; All zones are programmable as
Entry/Exit, Instant, Follower or 24 hour;
 One Keyswitch/Tamper zone;
 Keypad programming;
 Master code and 3 user codes, all programmable;
 Optional Ambush code (code 4);
 Quick arming, Stay arming, Instant stay arming;
 Optional Forced arming for Entry/Exit and Follower zones;
 Optional zone bypassing;
 Programmable Chime function;
 Programmable siren alarm type: Steady, Pulse or Silent;
 Programmable Entry delay, Exit delay;
 Optional Keyswitch arming/disarming;
 9 options for 2 programmable outputs which are: Latch alarm, Arming/
Disarming, Entry delay, Exit delay, System Trouble, Steady siren, Pulsing
siren, Silent alarm or Panic;
 First 9 alarm events which have occurred since the last arming are
displayed on keypad;
 7 programmable phone numbers for one message transmission (Cerber
C41V1 control panel), respectively 4 messages (Cerber C41V4 control
panel);