Cerber
®
C41V1/Cerber
®
C41V4
HOOKUP INSTALLATION & PROGRAMMING BOOK
9
For Cerber C41V4 control panel, using the Ambush code when disarming,
the panel will transmit a special phone message meaning the system was
disarmed under threat.
Code modifying , including Master code, is made by [*][7][Master Code]
command.
INSTALLER'S CODE
The default Installer's Code is 0269.
This code achieves parameter programming by [*][8][Installer's code]
command.
The installer should change this code after mounting the system!
ARMING
Before arming the system, make sure that all protected doors and windows
have been closed.
If the SYSTEM LED is lit, check the following:
- the alarm memory ([*][5] command). If there are alarms in the memory, it
will be cleared when arming the system.
- bypassed zones ([*][3] [Access code] command). Ensure that each zone
displayed as being bypassed is intentionally bypassed.
- system trouble ([*][4] command). If there are troubles with the battery or the
AC power, fix them before arming.
If "READY" LED is not lit, then one or more zones are open. One cannot
arm the system if the system is not ready meaning that "READY" LED
should be lit.
To arm the system, introduce a 4 digit access code. When pressing each
key, the keypad buzzer will sound a short beep.
After pressing the access code, the "ARMED" LED will turn on and the
keypad buzzer will sound 6 beeps.
If the access code is not correct, the keypad buzzer will sound a long beep.
Press the [#] key and then press the access code again.
After pressing the access code and the "ARMED" LED was lit, exit the
protected area through the Entry/Exit zone, before the Exit time was over.
After the Exit time was over, all LEDs will be off, except the "ARMED" LED.
The default Exit time is 120 seconds.
To Next Page
Loading...
