To Next Page
S
Sarah MorseAug 4, 2025
Why Roger Technology Control Systems barrier does not open and does not close?
- HHannah JacobsAug 5, 2025
If the Roger Technology Control Systems barrier doesn't open or close, several factors could be at play. First, check the mains power supply to ensure the unit is receiving power. Another potential issue is an unlocked gear motor; if this is the case, lock the gear motor (refer to the instructions for unlocking). Also, verify the transmitter's battery and replace it if it's flat. If these steps don't resolve the issue, the transmitter might be broken, or the STOP button may be stuck or faulty. Contact technical support service in these cases. Also, open/close buttons or key selector switch might be stuck.
General