Roger Technology B70/2DC/BOX - Display function modes; Parameter display mode; Command and safety device status display mode

EN
42
7 Display function modes
7.1 Parameter display mode
4%6%1)8)6
4%6%1)8)6
VALUE
See chapter 10 for detailed descriptions of the parameters.
7.2 Command and safety device status display mode
BM20 - BR20 - BR21 -BE20 - MONOS4 Serie
COMMAND STATUS 7%*)8=():-')78%897
AP PED
ORO
FT1
COS1
COS2
FT2
PP
CH
POWER STOP
COMMAND STATUS:
The command status indicators on the display
WIKQIRXW%4!STIR44!WXITQSHI',!GPSWI
PED = partial opening 363! GPSGO are normally
off. They illuminate when a command is received
(e.g.: when a step mode command is received, the
segment PP illuminates).
SAFETY DEVICE STATUS:
The safety device status indicators on the display
(segments *8*8!photocells '37'37 !
sensing edge, STOP) are normally on. If an indicator is off, the relative device is in alarm state or is not connected.
8LIERMRHMGEXSVMWƽEWLMRKXLIVIPEXMZIHIZMGILEWFIIRHMWEFPIH[MXLEWTIGMƼGTEVEQIXIV
BH23 Serie
COMMAND STATUS 7%*)8=():-')78%897
AP PED
ORO
FT1
COS1
COS2
FCA2
FCA1
FT2
PP
CH
POWER STOP
COMMAND STATUS:
The command status indicators on the display
WIKQIRXW%4!STIR44!WXITQSHI',!GPSWI
PED = partial opening) are normally off. They
illuminate when a command is received (e.g.: when
a step mode command is received, the segment PP
illuminates).
SAFETY DEVICE STATUS:
The safety device status indicators on the display
(segments *8*8!photocells, COS1=sensing
edge*'%*'%!KEXISTIRPMQMXW[MXGLIWMJIREFPIH7834are normally on. If an indicator is off, the relative device
is in alarm state or is not connected.
8LIERMRHMGEXSVMWƽEWLMRKXLIVIPEXMZIHIZMGILEWFIIRHMWEFPIH[MXLEWTIGMƼGTEVEQIXIV
N.B.: If the gate open limit switches are enabled ( = XLIGSHIW363ERH'37ƽEWL
N.B.: If the gate open limit switches are NOT enabled ( = XLIGSHIW*'%ERH*'%ƽEWL