Roger Technology B70/2DC/BOX - Alarms and faults

EN
60
13 Alarms and faults
PROBLEM ALARM POSSIBLE CAUSE ACTION
The gate does not open
or close.
POWER LED off No power. Check power cable.
POWER LED off Fuses blown. 6ITPEGIJYWI
Always disconnect from mains power before
removing fuses.
2) 6W
Input mains power voltage fault.
Control initialisation failed.
Disconnect from mains power, wait
10 seconds then reconnect to the mains and
switch on.
We recommend replacing the control unit if the
problem persists.
3U 2W
Overcurrent detected in inverter. Press the TEST button twice or perform 3 com
mand requests in succession.
G$ W$
Incorrect travel length values. Press the TEST button and check the safety
HIZMGIWMREPEVQWXEXIERHXLIGSRRIGXMSRWSJ
the safety devices.
'LIGO XLEX XLI 13836  ERH 13836  PMQMX
switches are positioned correctly.
6ITIEXEGUYMWMXMSRTVSGIHYVI

Motor 1 not connected. Check the motor cable.

Motor 2 not connected. Check the motor cable.
Example:
 HH
 HH
'SRƼKYVEXMSRTEVEQIXIVIVVSV 7IXGSRƼKYVEXMSRZEPYIGSVVIGXP]ERHWEZI
EW/2
(btLO)
Flat batteries. Wait for mains power to be restored.
Acquisition procedure
does not complete
correctly.
$3 3.(
TEST button pressed accidentally. 6ITIEXEGUYMWMXMSRTVSGIHYVI
Safety devices in alarm state. Press the TEST button and check the safety
HIZMGIWMREPEVQWXEXIERHXLIGSRRIGXMSRWSJ
the safety devices.
Excessive voltage drop. 6ITIEXEGUYMWMXMSRTVSGIHYVI
Check mains voltage.
DS S/
Travel length error. Move gate into completely closed position and
repeat the procedure.
'LIGOGEFPISJPMQMXW[MXGLIWMJMRWXEPPIH6I
place the cable if the problem persists.
6IWIXHIJEYPXGSRXVSPYRMXTEVEQIXIVWERHVITI
at the procedure.
6IQSXIGSRXVSPLEWPMQ
ited range and does not
work while automated
gate is moving.

The radio transmission is impeded
by metal structures and reinforced
concrete walls.
Install the antenna outside.

Flat batteries. 6ITPEGIXLIXVERWQMXXIVFEXXIVMIW
8LIƽEWLMRKPMKLXMWRSX
working.

&YPF  0)( FPS[R SV ƽEWLMRK PMKLX
wires disconnected.
'LIGO0)(GMVGYMXERHSVGSRRIGXSV[MVIW
Gate open indicator
lamp does not work.

Bulb blown or wires disconnected. 'LIGOXLIFYPFERHSV[MVIW
Gate does not perform
desired manoeuvre.

Motor leads crossed. 7[ETX[S[MVIWSRXIVQMREP<=>SV>=<
N.B.: Press the TEST button to temporarily cancel the alarm.
The next time a command is received, the alarm reappears on the display if the problem has not been resolved.