Roger Technology B70/2ML - User Manual

3
A
3
3
5
2
2
4
3
Quick Start B70/2ML
Rev00 11/11/2020
ROGER TECHNOLOGY
Via S. Botticelli 8 • 31021 Bonisiolo di Mogliano Veneto (TV) • ITALIA
P.IVA 01612340263 • Tel. +39 041.5937023 • Fax. +39 041.5937024
info@rogertechnology.com • www.rogertechnology.com
A
Power supply B70/2ML - Motors 3x2,5 mm
2
double insulated cable (max.10 m) - 3x4 mm
2
(max. 30 m)
1
Photocell - Receiver 5x0,5 mm
2
double insulated cable (max.20 m)
2
Photocell - Transmitter 3x0,5 mm
2
double insulated cable (max.20 m)
3
Flashing lamp unit 2x1 mm
2
double insulated cable (max.10 m)
4
Antenna RG58 50 Ohm cable for external use (max.10 m)
5
Selector / Keypad 3x0,5 mm
2
cable (max.20 m)
1. Typical installation
B70/2ML is the range of 24V DC digital controllers installed in the swing gates product.
EN
All manuals and user guides at all-guidesbox.com
all-guidesbox.com

Roger Technology B70/2ML Specifications

General

Operating Temperature	-20°C to +55°C
Protection Class	IP44
Encoder	Yes
Control Type	Electronic
Safety Features	Obstacle detection
Voltage	230V

Summary

Electrical Connections

Motor 2 Electrical Connections

Illustrates electrical connections for Motor 2.

Motor 1 Electrical Connections

Illustrates electrical connections for Motor 1.

Display Functions and Settings

Display for Programming and Error Checks

Explains display functions for programming and error checks.

Parameter Adjustment on Display

Details how to adjust parameters and view values on the display.

Before Starting Setup

Select Automation System Model

Guide to selecting the correct automation system model.

Set Motor Position Relative to Gate

Instructions for setting motor position relative to the gate.

Position Mechanical Stops

Guidance on setting mechanical stops for gate positions.

Ensure Gate is in Closed Position

Action to ensure the gate is fully closed before proceeding.

Press Test Button for Initial Checks

Alarm and Safety Device Messages

Acquisition Procedure

Initiate Acquisition Sequence

Step-by-step guide to initiating the acquisition sequence.

Motor Movement During Acquisition

Describes motor actions during the acquisition process.

Display Feedback During Acquisition

Setting Basic Parameters

Motor 1 Deceleration Settings

Gate Position Control

Motor 1 Opening Stop Advance

Motor 1 Closing Delay

Motor 1 Acceleration Settings

Approach Distance Settings

Motor Torque Adjustment

Motor 1 Obstacle Sensitivity

Motor 2 Deceleration Settings

Motor 2 Acceleration Settings

Motor 2 Torque Adjustment

Motor 2 Obstacle Sensitivity

Gate Speed Settings

Motor 2 Opening Delay

Motor 2 Approach Distance Settings

Leaf 2 Opening Stop Advance

Programming a New Transmitter

Receiver Channel Programming

Procedure for programming a new transmitter to receiver channels P1 or P2.

Copying a Transmitter

Transmitter Copying Procedure

Steps to copy an existing transmitter to a new one.