Roger Technology BRUSHLESS B70/2DC - Simplified;Extended Parameters; Mode Change; Standby Mode; Restoring Standard Factory Param- Eters

25

0- C- 


        

3.5.2.2 Restoring standard factory pa-
rameters
N.B.: this procedure is only possible if you have not
entered the password to protect your data.




rE S-


N.B.: parameter A1 in extended mode (C-in
simplied mode) is not restored; it must always be
set manually.
3.5.2.3 Simplied/extended parameters
mode change
      

        
       

       





       
      



A





 

    A      
      





N.B.: the sequence of parameters for simplied
mode is not the same as that of extended mode,
therefore always refer to the instrucons or the
label on the inside of the cover.
3.5.3 Standby mode

       

    

         



3.5.4 TEST mode





Name of the active input
(displayed for 5 seconds)
safety protection terminal
block number in a state of
alarm (ashing, displayed
until the safety protection
goes back to resting)
AP
CH
PP
PE
Or
23 = ST
21 = COS1
20 = COS2
19 = FT1
18 = FT2
27 = FCA1
20 = FCA2
highest
priority
lowest
priority