Common Analysis and Display Functions
R&S
®
ESW
251User Manual 1177.6298.02 ─ 08
Remote command:
CALCulate<n>:LIMit<li>:CONTrol[:DATA] on page 569
CALCulate<n>:LIMit<li>:LOWer[:DATA] on page 570
CALCulate<n>:LIMit<li>:UPPer[:DATA] on page 573
Insert Value
Inserts a data point in the limit line above the selected one in the "Edit Limit Line" dia-
log box.
Delete Value
Deletes the selected data point in the "Edit Limit Line" dialog box.
Shift x
Shifts the x-value of each data point horizontally by the defined shift width (as opposed
to an additive offset defined for the entire limit line, see "X-Offset" on page 247).
Remote command:
CALCulate<n>:LIMit<li>:CONTrol:SHIFt on page 570
Shift y
Shifts the y-value of each data point vertically by the defined shift width (as opposed to
an additive offset defined for the entire limit line, see "Y-Offset" on page 248).
Remote command:
CALCulate<n>:LIMit<li>:LOWer:SHIFt on page 572
CALCulate<n>:LIMit<li>:UPPer:SHIFt on page 574
Save
Saves the currently edited limit line under the name defined in the "Name" field.
Import
Opens a file selection dialog box and loads the limit line from the selected file in .CSV
format.
"File Explorer": Instead of using the file manager of the R&S ESW firmware, you can
also use the Microsoft Windows File Explorer to manage files.
Note that a valid import file must contain a minimum of required information for the
R&S ESW.
Remote command:
MMEMory:LOAD<n>:LIMit on page 567
File Explorer ← Import
Opens the Microsoft Windows File Explorer.
Remote command:
not supported
Export
Opens a file selection dialog box and stores the currently displayed limit line to the
defined file in .CSV format.
Display and Limit Lines
To Next Page
Loading...
