Network and Remote Operation
R&S
®
ESW
390User Manual 1177.6298.02 ─ 08
Bit No. Meaning
4 to 14 Unused
15 This bit is always 0.
STATus:QUEStionable:TIMe Register
Available for the Spectrum application.
The STATus:QUEStionable:TIMe register contains information about possible time
errors that may occur during operation of the R&S ESW. A separate time register
exists for each active channel.
Table 14-18: Meaning of the bits used in the STATus:QUEStionable:TIMe register
Bit No. Meaning
0 not used
1 Sweep time too low
This bit is set if the sweep time is too low.
2 to 14 Unused
15 This bit is always 0.
STATus:QUEStionable:TRANsducer Register
Available for the Receiver application.
The STATus:QUEStionable:TRANsducer register contains information about the state
and condition of measurements with transducer sets. A separate TRANsducer register
exists for each active channel.
It indicates that a transducer break has been reached. It also indicates the next range
that is to be swept. You can continue the sweep with INITiate<mt>:CONMeas
on page 440.
You can read out the register with STATus:QUEStionable:TRANsducer:
CONDition? or STATus:QUEStionable:TRANsducer[:EVENt]? on page 677.
Table 14-19: Meaning of the bits used in the STATus:QUEStionable:ACPLimit register
Bit No. Meaning
0 Range 1
This bit is set if subrange 1 has been reached.
1 Range 2
This bit is set if subrange 2 has been reached.
2 Range 3
This bit is set if subrange 3 has been reached.
3 Range 4
This bit is set if subrange 4 has been reached.
4 Range 5
This bit is set if subrange 5 has been reached.
Remote Control Basics
To Next Page
Loading...
