Rohde & Schwarz ESW44 - Page 478

Remote Commands in the Receiver Application
R&S
®
ESW
478User Manual 1177.6298.02 ─ 08
Example: //Query level of the fourth peak
CALC:FME:PLIS4:LEV?
//Return value example:
-53.99
CALCulate<n>:FMEasurement:PLISt<pi>:SIZE?
This command queries the number of peaks measured in the final measurement.
Suffix:
<n>
.
irrelevant
<pi> irrelevant
Return values:
<Peaks>
Example: //Query size of peak list
CALC:FME:PLIS:SIZE
Return value example:
100
Usage: Query only
CALCulate<n>:FMEasurement:PLISt<pi>:TRACe?
This command queries the trace that a peak measured in the final measurement is
located on.
Suffix:
<n>
.
irrelevant
<pi> Peak
Return values:
<Trace> String that contains the trace number.
Example: //Query trace of the peak
CALC:FME:PLIS4:TRAC
//would return, e.g.
'TRACE1'
Usage: Query only
CALCulate<n>:FMEasurement:PLISt<pi>[:DATA]?
This command queries the information for a peak measured in the final measurement.
Suffix:
<n>
.
irrelevant
<pi> Peak
Return values:
<PeakResults> List of values for the selected peak.
Measurements and Result Displays