Firmware Update
R&S
®
FPC
33User Manual 1178.4130.02 ─ 07
The booting process continues. After a couple of seconds, the R&S FPC asks you
if you really want to update the firmware.
9. Press the "Enter" ("✓") key to update the firmware.
(You can cancel the firmware update with the "Esc" key.)
The firmware update takes several minutes. The R&S FPC shows a message
when the firmware update is done.
Note: Do not turn off the R&S FPC during the firmware update.
10. Turn off the R&S FPC.
11. Turn on the R&S FPC.
The R&S FPC boots with the new firmware version.
12. Optional: It is recommended to perform a factory reset after a firmware update to
replace the predefined limit lines, channel tables and other data with the latest
updates.
Note: Before you start a factory rest, make sure to make a backup of your data that
you have saved on the R&S FPC. Otherwise that data is deleted.
To Next Page
Loading...
Need help?
General
