Instrument Setup
R&S
®
FPC
43User Manual 1178.4130.02 ─ 07
3. Select the "Date Format" menu item in the "Regional" category.
4. Select the date format of your choice.
● "dd/mm/yyyy": day/month/year
● "mm/dd/yyyy": month/day/year
Selecting the length unit
1. Press the "Setup" key to open the setup menu.
2. Select the "Instrument Setup" menu item to open the instrument setup dialog box.
3. Select the "Length Unit" menu item in the "Regional" category.
4. Select the length unit of your choice.
● "Meter": metric length unit
● "Feet": imperial length unit
9.5 Display Settings
Remote commands required to configure the display:
●
Chapter 19.6, "Display Settings", on page 215
Adjusting the display backlight
The display backlight defines the brightness of the display.
You can adjust the backlight intensity of the display to get a good viewing experience
depending on the lighting conditions of your surroundings.
1. Press the "Setup" key to open the setup menu.
2. Select the "Instrument Setup" menu item to open the instrument setup dialog box.
3. Select the "Display Backlight" menu item in the "Display" category.
4. Select the backlight intensity that you prefer.
The backlight intensity is a percentage from 0 % to 100 % with 100 % being the
brightest.
9.6 Audio Settings
Remote commands required to configure the audio output:
●
Chapter 19.7, "Audio Settings", on page 215
Audio Settings
To Next Page
Loading...
Need help?
General
