R&S FSH Putting into Operation
Configuring the R&S FSH
Quick Start Guide 1309.6269.12 - 09 42
1.6.7 Configuring Audio Output
The audio settings control the audio output of the system.
Setting the key click volume
The key click volume sets the volume of the sound that the R&S FSH produces when
you press a key or softkey.
► In the "Instrument Setup" dialog box, select the "Key Click Volume" item.
► Press the ENTER key.
► Enter the volume you want with the numeric keys.
The key click volume is a percentage from 0% to 100% with 100% being the
loudest.
► Confirm the entry with the ENTER key.
Setting the system beeper volume
The system beeper volume sets the volume of the system beeper of the R&S FSH,
used for example if a message box pops up.
► In the "Instrument Setup" dialog box, select the "System Beeper Volume" item.
► Press the ENTER key.
► Enter the volume you want with the numeric keys.
The system beeper volume is a percentage from 0% to 100% with 100% being the
loudest.
► Confirm the entry with the ENTER key.
Turning audio output in case of a power overload on and off
In case the R&S FSH detects an overload at one of its inputs, you can configure it to
make a sound.
► In the "Instrument Setup" dialog box, select the "Beep on Power Overload" item.
► Press the ENTER key.
► Turn the beeper on or off.
When this feature is on, the R&S FSH will make a sound every time it detects an
overload.
► Confirm the entry with the ENTER key.
To Next Page
Loading...
