R&S FSH Putting into Operation
Configuring the R&S FSH
Quick Start Guide 1309.6269.12 - 09 43
1.6.8 Configuring Power Supply
The power settings contain settings that configure the power supply of the R&S FSH.
The "Current Power Source" shows the source the R&S FSH is currently powered by.
When you are using the battery to supply the R&S FSH with power, the remaining
"Battery Level" is displayed as a percentage, with 100 % representing a full charge.
Setting the battery low level
The battery low level is a reminder that the remaining battery charge might be used up
soon.
When the battery low level is reached, the battery symbol in the title bar turns red and
starts blinking.
► In the "Instrument Setup" dialog box, select the "Battery Low Level" item.
► Press the ENTER key.
► Enter the charge level in percent of a fully charged battery with the numeric keys.
► Confirm the entry with the ENTER key.
Turning audio output in case of battery low level state on and off
The R&S FSH also allows you to turn on an audio signal that indicates that the battery
has reached its low level state.
► In the "Instrument Setup" dialog box, select the "Battery Low Level Beep" item.
► Press the ENTER key.
► Select either "Repetitive" or "Once" to turn the audio signal on.
If you have selected "Once", the R&S FSH will beep once if the battery runs out of
power. For a continuous beep, select "Repetitive".
► Select "Off" to turn off the beeper.
To Next Page
Loading...
