Front and Rear Panel View
R&S
®
FSVA/FSV
28Quick Start Guide 1321.3066.02 ─ 06
3.2.1.6 REF OUT
This connector can be used to provide an external reference signal (e.g. the
OCXO or ultra high precision reference signal) to other devices that are connec-
ted to this instrument. The REF OUT female connector can output a 10 MHz ref-
erence signal with an output level of 0 dBm.
3.2.1.7 GPIB interface
The GPIB interface is in compliance with IEEE488 and SCPI. A computer for
remote control can be connected via this interface. To set up the connection, a
shielded cable is recommended. For more details refer to chapter 7 "Remote
Control Basics" in the Operating Manual.
3.2.1.8 TRIGGER OUTPUT
The female BNC connector can be used to provide a signal to another device.
The signal is TTL compatible (0 V / 5 V). The "Trigger out" softkey in the "In-/
Output" menu (INPUT/OUTPUT key) is used to control the trigger output.
3.2.1.9 IF/VIDEO
The female BNC connector can be used for various outputs:
●
Intermediate frequency (IF) output of approximately 20 MHz
●
Video output (1V)
The "In-/Output" menu (INPUT/OUTPUT key) is used to select between the IF
and video output.
3.2.1.10 USB
The rear panel provides two additional female USB connectors to connect devi-
ces like keyboard and mouse. Also, a memory stick can be connected to store
and reload instrument settings and measurement data.
Rear Panel View
To Next Page
Loading...
