Instrument Tour
R&S
®
FSW
47Getting Started 1338.4102.02 ─ 08
5.1.14 PHONES and VOLUME
You can use headphones to monitor demodulated audio frequencies in time
domain measurements acoustically.
Connect headphones equipped with a miniature jack plug to the PHONES female
connector. Set the output voltage using the "Volume" control to the right of the
female connector. The maximum output voltage (volume) is 1 V. If a headphone is
plugged into the instrument, the internal loudspeaker is automatically switched
off.
The output provided to the PHONES connector is the same as the (video) output
at the IF/VIDEO/DEMOD OUTPUT connector.
See also "Connecting headphones" on page 10.
5.1.15 SYSTEM Keys
[SYSTEM] keys set the instrument to a predefined state, change basic settings,
and provide print and display functions.
A detailed description of the corresponding functions is provided in the User Man-
ual.
Table 5-3: SYSTEM keys
SYSTEM key Assigned functions
[PRESET] Resets the instrument to the default state.
[MODE] Provides the selection between applications
[SETUP]
Provides basic instrument configuration functions, e.g.:
●
Reference frequency (external/internal), noise source
●
Date, time, display configuration
●
LAN interface
●
Self-alignment
●
Firmware update and enabling of options
●
Information about instrument configuration incl. firmware ver-
sion and system error messages
●
Service support functions (self-test etc.)
Switches between the on-screen keyboard display:
●
At the top of the screen
●
At the bottom of the screen
●
Off
Front Panel View
To Next Page
Loading...
