Trying Out the Instrument
R&S
®
FSW
81Getting Started 1338.4102.02 ─ 08
To load stored instrument settings
You can restore the settings to the instrument at any time using the settings file.
1. Press the [PRESET] button to restore the default instrument settings so you
can check that the stored user settings are actually restored afterwards.
2. Tap the "Load" icon in the toolbar.
3. In the "Load" dialog box, select the MyMultiViewSetup.dfl file in the
default directory C:/R_S/instr/user.
4. Tap the "Load" button.
All instrument settings are restored and the display should resemble Fig-
ure 6-16, which shows the instrument display right before the settings were
stored.
6.10 Printing and Saving Results
Finally, after a successful measurement, we will document our results. First we
will export the numeric trace data, then we will create a screenshot of the graphi-
cal display.
To export the trace data
1. Press the [TRACE] key on the front panel.
2. Tap the "Trace Config" softkey.
3. Tap the "Trace Export" tab.
4. Tap the "Export Trace to ASCII File" button.
5. Enter the file name MyPeakResults using the external or onscreen keyboard.
The trace data is stored to MyPeakResults.DAT
Printing and Saving Results
To Next Page
Loading...
