Rohde & Schwarz FSW50 - Controlling the Positive Transition Part; Commands for Remote Instrument Operation

Remote Commands
R&S
®
FSW
1048User Manual 1173.9411.02 ─ 19
Setting a bit causes a 1 to 0 transition in the corresponding bit of the associated regis-
ter. The transition also writes a 1 into the associated bit of the corresponding EVENt
register.
Parameters:
<SumBit> Range: 0 to 65535
<ChannelName> String containing the name of the channel.
The parameter is optional. If you omit it, the command works for
the currently active channel.
11.11.6 Controlling the Positive Transition Part
For more information on the negative transition part see chapter 10.1.7.2, "Structure of
a SCPI Status Register", on page 629.
STATus:OPERation:PTRansition <SumBit>
STATus:QUEStionable:PTRansition <SumBit>
STATus:QUEStionable:ACPLimit:PTRansition <SumBit>,<ChannelName>
STATus:QUEStionable:EXTended:PTRansition <SumBit>,<ChannelName>
STATus:QUEStionable:EXTended:INFO:PTRansition <SumBit>,<ChannelName>
STATus:QUEStionable:FREQuency:PTRansition <SumBit>,<ChannelName>
STATus:QUEStionable:LIMit<n>:PTRansition <SumBit>,<ChannelName>
STATus:QUEStionable:LMARgin<n>:PTRansition <SumBit>,<ChannelName>
STATus:QUEStionable:POWer:PTRansition <SumBit>,<ChannelName>
STATus:QUEStionable:TEMPerature:PTRansition <SumBit>,<ChannelName>
STATus:QUEStionable:TIME:PTRansition <SumBit>,<ChannelName>
These commands control the Positive TRansition part of a register.
Setting a bit causes a 0 to 1 transition in the corresponding bit of the associated regis-
ter. The transition also writes a 1 into the associated bit of the corresponding EVENt
register.
Parameters:
<SumBit> Range: 0 to 65535
<ChannelName> String containing the name of the channel.
The parameter is optional. If you omit it, the command works for
the currently active channel.
11.12 Commands for Remote Instrument Operation
The following commands are required to shutdown or reboot the R&S FSW from a
remote PC.
SYSTem:CLOGging..................................................................................................... 1049
SYSTem:REBoot......................................................................................................... 1049
SYSTem:SHUTdown....................................................................................................1049
Commands for Remote Instrument Operation