Rohde & Schwarz Hameg HMP4040 - 8 Appendix; Glossary; List of Figures

35
Subject to change without notice
Appendix
8 Appendix
Glossary
A rbitrary: 28, 31, 33, 34, 30
Arbitrary Editor: 30, 31
Beeper: 31, 33, 30
Common Commands: 32
cooling: 24, 25
CURRENT: 28, 29, 30
current limits: 29, 30, 34
dual interface: 28, 32
EasyArb function: 27
Edit waveform: 31
electronic fuse: 29, 30
Fuse linking: 30
Fuse replacement: 25
GPIB Interface: 31
HAMEG Knowledge Base: 32
HAMEG service dept: 25
Interface: 31, 30
Key Brightness: 31, 30
Load: 28, 29, 31, 34
Mains voltage: 25
Maintenance: 25
Menu options: 30
Noise: 29
Numerical keyboard: 28, 29
Operating temperature: 24
OUTPUT: 28, 29, 31
overload: 28, 34
Over Voltage Protection: 31, 33, 30
Parallel operation: 34
Power hyperbola: 29
Power management: 27
Program Commands: 32
Rack mount system: 28
RECALL: 21, 30
Recall Waveform: 30, 31
Remote Control: 32
Repair: 25
Reset Device: 31, 30
Residual ripple: 27
Return material authorization: 25
Ripple: 27, 29
Safety instructions: 24
Save Waveform: 30, 31
SCPI commands: 32, 33
Series operation: 34
Start Waveform: 30, 31
Stop Waveform: 30, 31
Storage: 24
STORE: 30
Tracking function: 30
Transfer Waveform: 30, 31
Transport: 24
VOLTAGE: 28, 29, 30
voltage parameters: 28
Warranty: 25
Windows HyperTerminal: 32
List of Figures
Fig. 2.1: Front panel HMP4040 26
Fig. 2.2: Rear panel HMP4030 27
Fig. 3.1: HMP4030 (3 channel version) 27
Fig. 3.2: Fuse Linking aktivated 28
Fig. 3.3: Arbitrary voltage step 28
Fig. 3.4: Outputs on the rear panel 28
Fig. 4.1: Available maximum values of HMP4040 28
Fig. 4.2: Available maximum values of HMP4030 29
Fig. 4.3: Current limit 29
Fig. 4.4: HMP4030/4040 power hyperbola 29
Fig. 4.5: Display of FUSE for each channel 29
Fig. 5.1: 1 V decimal position of all three channels 30
Fig. 5.2: HMP4030/40 main menu overwiew 30
Fig. 5.3: Activated Fuse linking shown in the display 30
Fig. 5.4: FUSE Linking 30
Fig. 5.5: Arbitrary Editor 31
Fig. 5.6: OVP and activated fuse 31
Fig. 5.7: Beeper 31
Fig. 7.1: Compensation of the voltage drop across
the cables (drawing) 34
Fig. 7.2: Series operation 34
Fig. 7.3: Parallel operation 34