Subject to change without notice
P r o b e H Z O 3 0
About the Probe HZO30
HAMEG Instruments GmbH presents a unique
Inline Probing System – the HZO30 active probe
which can contact adjacent square pins in 2.54
mm pitch simultaneously. The probe‘s housing is
T-shaped so that many probes can be positioned
next to each other in a never ending chain.
Like this a number of measurements can be per-
formed at the same time. The HZO30 active probe
is system-independant and its standard BNC
connector can be plugged onto any measuring
instrument with a 50Ω input.
With an input resistance of 1 MΩ and an input
capacitance of 0.9 pF the HZO30 active probe
is suitable for measurements in all frequency
ranges. Compared to passive probes the HZO30
active probe offers a high input impedance into
the GHz-range. Passive probes with their relative
high input capacitance load the signal source
already at frequencies above 100 kHz.
That´s why the HZO30 active probe with its high
input resistance and its low input capacitance is
the ideal probe for most of your daily measur-
ments.
The HZO30 testing adjacent pins in 2.54 mm Pitch
Included in delivery
The following items are included in the scope of
delivery. Please check the delivery for comple-
teness. If any item is missing, send a message to
our service department and we will send you this
item immediately.
Item Qty
Instruction Manual 1
Spring Tip 0.5 mm 1
Solid Tip 0.5 mm 1
Ground Blade 1
Marker Bands 4 colors 1
L-In Adapter 1
Ground Lead 6 cm 1
Ground Lead 12 cm 1
Ground Lead 90° 5cm 1
Ground Lead 90° 10cm 1
Power Supply 1
PicohookTM black 1
PicohookTM red 1
Protection Cap 2.5 1
self adhesive Cu Pad (2 x 2 cm) 2
Probe 1
Y-Lead Adapter to 0.8mm sockets 1
Z-Ground 1
Use ground lead only for connections to
earth ground
The accessories provided with the probe
have been safety tested. Do not use any
other accessories than those “originally”
provided.
To Next Page
Loading...
