Rohde & Schwarz Hameg Instruments active PROBE HZO30 - Safety Information; General Safety Precautions; Safety Symbols

Subject to change without notice
Prob e HZ O 30
Safety Information HZO30
To avoid personal injury and to prevent re or
damage to this product or products connected
to it, review and comply with the following safety
precautions. Be aware that if you use this probe
assembly in a manner not specied the protection
this product provides may be impaired.
– Only qualied personnel should use this probe
assembly.
– Use only grounded instruments.
– Do not connect the probe ground lead to a poten-
tial other than earth ground. Always make sure
the probe and the measurement instrument are
grounded properly.
– Connect and disconnect properly.
– Connect the probe output to the measurement
instrument and connect the ground lead to earth
ground before connecting the probe to the circuit
under test. Disconnect the probe input and the
probe ground lead from the circuit under test
before disconnecting the probe from the mea-
surement instrument.
Observe probe ratings.
– Do not apply any electrical potential to the probe
input which exceeds the maximum ratings of the
probe.
– Make sure to comply with the voltage versus
frequency derating curve on page 8.
– Keep away from live circuits.
– Avoid open circuitry. Do not touch connections or
components when power is present.
– Do not operate with suspected failures.
– Refer to qualied service personnel.
– Indoor use only.
– Do not operate in wet/damp environment. Keep
product surfaces dry and clean.
– Do not operate the product in an explosive atmos-
phere.
Safety symbols
Die folgenden Symbole können auf dem Produkt
oder in dieser Bedienungsanleitung erscheinen:
Caution, risk of danger
Refer to manual
Caution, risk of electric schock
Earth (ground) terminal