In rare cases the error message 'RFB6.BB: Output unleveled: Gain
Control on Upper Limit' appears if the external reference frequency
was switched from external to internal.
1.3 Version 4.60.112.22
Released: May 2019
New Functionality / Changed Behavior
Sweep will be switched off in case of considerable overrun conditions.
List Mode will be switched off in case of considerable overrun
conditions.
A new value "Load Impedance" in certain emulations
Slide switches can be operated in remote state.
Improved Table Adjustment. Internal Adjustments have to be done.
Error handling: SYSTEM:SERROR? delivers info-messages, different
from SYSTEM:ERROR?
Frequency is recalled even in case of "Exclude Frequency"
The RF level is higher than expected.
In rare cases the level steps are different.
The trigger mode 'Ext Single' doesn't work.
1.4 Version 4.50.074.45
Released: Dezember 2018