Documenting results
R&S
®
RTM3000
217User Manual 1335.9090.02 ─ 09
Save
Opens a dialog box to save the current instrument setup to file.
To change the storage location, select "Destination" > "Location".
Change the filename if the auto name does not fit. The file extension SET is set auto-
matically. You can enter an optional comment that describes the setup.
Tap "Save" to start writing the data.
Remote command:
MMEMory:STORe:STATe on page 590
Load
Opens a file explorer to select an instrument setup file to be loaded to the instrument.
To change the storage location, select "Destination" > "Location".
Tap "Load" to change the settings.
Remote command:
MMEMory:LOAD:STATe on page 590
Import Export
Opens a menu to copy data between the instrument's internal storage "/INT/
SETTINGS" and a USB flash drive.
Make sure that the USB flash drive is connected.
See Chapter 10.6, "Export and import", on page 225 for a procedure description.
Memory Usage
Shows free memory space (absolute and relative) in the instrument's internal storage "/
INT" and used space per subdirectory in kbyte.
If a USB flash drive is detected, the free memory space in this device is also shown.
Factory Default
Resets the instrument to the factory settings.
Remote command:
SYSTem:PRESet
10.2 Saving waveform data
Waveform data is always saved to USB flash drive. The waveform export provides the
following possibilities:
●
Store either one waveform or all active waveforms.
●
Option R&S RTM-K15: Save history data.
●
Option R&S RTM-B1: Save logic channels.
To save waveforms:
1. Activate the waveforms that you want to export.
Saving waveform data
To Next Page
Loading...
