Rohr HP-200PP - Health and Safety

HP-160L
/ HP-200PP/
HP-250PP
ROHR
Health
and
Safety
\
Warning
=
Risk of
injury.Pay
Caution
-
Be aware of
potential
special
attention
risks / hazards
If
you
fail
to
fully
understand this manual
you
should contact
the
suppliers
or
another
professional
for
assistance.
1.
Safety
cut
out
-
the
welding
machine hasa
safety
circuit to
protect
against excess-power,
current or
heat. This circuit will cause
the
welding
machine to cut out automatically
if
activated. The fans will
continue to
cool the unit.
2. Machine air flow
-
the internal fan
requires
a free flow ofair.
Ensure
the intakeis not
blocked or
covered:
3. Do
not overload
-
overloaded
input
current will
impair
the
performance
and
may
seriously
damage
the machine.
4.
Grounding
-
the
welding
machine must be
grounded by
means of.the
grounding
connector
at the
rear of the machine,
fitted
to
ground
as
per.the
required
standard.
5.
Cleaning
-
before
cleaning,
the
power
must be turned off and
disconnected
fromthe
mains. All
cleaning
should'be carried out
by
a
qualified
professional.
Remove dust
usinglow
pressure compressed
air to avoid
damage
to
fragile components
inside the machine.
Electric shock
-
may
lead
to death.
e
-An
isolator switch
is.recommended when
using
the. machine.
e-
|tis
dangerous
to touch the
electrical;components.
¢
Wear
welding gloves,ear,
eye,
face
protection
and
clothing
/ ensure
others
nearby
are
protected.
e
Use suitable
protective equipment
or curtain to
protect any
on-lookers and
warnall
onlookers about the
possible
risk-to their
eyes.
e
Makesure
you
are well insulated
from.the
ground.
e
Make-sure
youre
in a safe
and secure
position.
e
Gas
may-be
harmful to
your
health,
do not
inhale-the-gas,
use an extractor.
©
Weldingsparks
may
cause
fire,
make sure the
welding
area is
fire safe.
A.
Arc
radiation can be harmful to
your eyes
and
can’burn
your
skin.
6 © Rohr