you will see the following screen:
In ON mode you can increase or decrease the brightness of the screen
by using the and buttons.
You can change the “Standby” mode brightness by pushing the button
to move the frame to the “STAND-BY” position. You can then adjust
the brightness by pushing the same and keys.
To finish the programming wait for 10 seconds without pressing any
buttons.
2. INSTALLATION & MOUNTING
The radiator must never be installed directly below a power point.
In bathrooms, the radiator must never be installed where the switches
and other devices may be within the reach of someone in the shower
or bathtub.
To Next Page
Loading...
