Roland Aerophone Pro AE-30 - Page 16

16
Making Settings in the Menu
Assigning Functions to Controllers (Assign)
You can assign functions to controllers such as the buttons and the thumb lever, and specify how the functions are controlled.
& For a list of the functions that you can assign, refer to “Aerophone Pro Parameter Guide” (PDF).
* The Assign parameters work when the settings in “Asgn Src” (assign source) of each controller of the system are set to “System.” If Asgn Src is set
to “Scene,” each scene’s assignment settings are used (p. 14).
1. Press the [MENU] button.
The Menu screen appears.
2. Long-press a [–][+] (C/A) button to select an “Assign” parameter.
MEMO
If you long–press a [–][+] (C/A) button, the menu type switches between System, Scene, Assign, and MIDI.
3. Press the [MENU] button.
The cursor position moves to the lower line.
4. Use the [–][+] (C/A) buttons to specify the upper/lower limits in which a continuously-operated controller will
function, or the values when a switch-type controller is pressed/released.
MEMO
You can long-press the [MENU] button to move to the USER/FAVORITE registration screen.
Assigning a continuously-variable controller
For breath (the strength of your breath), bite (the strength at which you bite the reed), thumb lever, and thumb pads, specify the following
parameters.
* Indications of “***” in the table will contain the following names. The rst parameter for Breath is shown as “Breath_1”, the second parameter for
S1 is shown as “S1_2” and so on.
Breath_1–8, BiteDn_1–4, BiteUp_1–4, LeverDn_1–2, LeverUp_1–2, ThumbPad_1–4
* For controllers whose Func parameter is “O,” their parameters related to the assign settings are not shown.
Parameter Indication Value Explanation
Assign Function *** Func
& “Aerophone Pro
Parameter Guide” (PDF)
Specify the function that is assigned to a continuously-operated controller.
Input Min Value *** In Min
0–127
Specify the minimum value (Min)
and maximum value (Max) in which
controller operations are eective.
& “Function assignment (continuous
operation)” (p. 17)
Input Max Value *** In Max
Output Min Value *** Out Min
0–127
Specify the minimum value (Min) and
maximum value (Max) in which the
assigned function operates.
Output Max Value *** Out Max
Mode *** Mode Momentary, Latch
Species the operation mode.
Momentary
The function operates like a graph (p. 17), according to
how you operate the controller.
Latch
Each operation switches between Output Min Value and
Output Max Value.
The switch occurs at the mid-point value between Input
Min Value and Input Max Value.