Roland CM-500 - Using Headphones

RS лл 22-402 Еч 2 еж 222222222 5002227 Т ы Ее
(2) Plug the other ends of the cables into the external input jacks (AUX IN or LINE ІМ)
of the audio device you're using. If the audio device inputs use RCA connectors,
remove the quarter-inch adaptors from the ends of the cables.
Be sure to match the L and R outputs of the CM-500 with the L and R inputs of the audio
device.
Under no circumstances should you connect the cables to the MIC IN or PHONES jack of
your audio equipment damage could result to the equipment or speaker systems.
@ Using Headphones
Use headphones that have an impedance between 8 and 150 ohms. Connecting head-
phones will have no effect on the signal output from the CM-500's Audio Outs.