Roland CR-80 - External Device Synchronization; CR-80 as Master Device

•
Using the CR-80
as a master device
To control
the
start/stop and tempo functions from the
CR-80, follow
this procedure.
1)
Connect the MIDI OUT
connector on the CR-80
to the MIDI
IN connector on the
external (slave) device.
2)
Set the
CR-80's Sync nnode to
"INT".
3)
Set the slave
device
to
MIDI Sync mode ( refer
to
the operation manual of the
slave device).
4)
Press the
CR-80's
C
START/STOP
) ,
and the
slave device
will sync to CR-80,
*
If the
slave
device can receive
MIDi Song Select
messages, the
Song Number
(1-4)
select-
ed on the CRSO
will
be
selected on the
slave
device.
39