Roland CR-80 - Reference Information; Factory Parameter Initialization; Troubleshooting Common Issues

1. To restore all
factory-set
parameter
values (this is
called
initialization).
1)
Switch off the CR-80.
2)
Switch
on the
unit
while
holding both
( 4
/DEL
)
and
(REPEAT)
Press ENTER
„
3)
Press
(
ENTER
)
.
The
display will read
"Complete.
To
cancel initialization, press any key but
C
ENTER
)
2. Troubleshooting
<When using
the CR-80
on its own>
No sound
is
heard
Check the volume
level of the CR-80.
Check the volume level of CR-80, any amplifier,
mixer, PA
system etc. (Page
11}
Check if
a
Level
Slider is lowered.
If
a Level Slider is
at
the lowest position, the corresponding
percussion group will
not be heard.
(Page
11)
-The CR-80 will not start playing.
The tempo
does
not change
Check if the SYNC mode is
set
to "INT*.
If
not,
set
the SYNC mode
to
"INT"
(Page
38).
Check if
the selected song contains
data.
If not,
program
a
song
in the Song Edit
mode or select
a song that contains
data
(Page
24).
Check if
a
tempo written in the
Rhythm Style or
a song has
been
set.
.Rotate the Tempo control knob to the position
of
Ihe tempo written in
memory then change the
tempo
(page
11 and
27).
The tempo
automatically
changes when
a different Rhythm Style is selected,
Determine
if you
selected
a
Rhythm Style while
the CR-80 was
stopped.
If
you
select
a
Rhytm Slyle with
the
CR-80 stopped, the tempo of the
selected rhythm style
is
automatically set {Page
11),
When you select a different
Rhythm Style,
the volume balance
of the percussion
sound changes.
The volume
balance set
with the Level Sliders is written
into the memory of each Rhythm
Style
(Page
11).
46