Roland CR-80 - Troubleshooting MIDI and Keyboard Issues; MIDI Sync and Volume Problems

-
When
you p!ay a different song,
the tempo
changes.
•Each
song is
programmed with
a
different
tempo (Page
27).
The Repeat function
cannot be set.
Determine
if
you are trying to set a Repeat inside
a set of
Repeat marks.
{Page
26).
The Restart function
does not work.
Check if
the CR-80
is
in the Song Play mode.
The
Restart function
is valid only in
the
Normal mode
(Page
18).
Even if you select
a different drum
set, the
Itey pad sound
does
not
change.
The
"DRY" and "MT-E-CM"
sets contain basically
the same
percussion
sounds
(Page
41).
<When using
the CR-80
to accompany
a
MIDI keyboard>
-The CR-80
does
not
sync-start with
the keyboard.
Check if the
MIDI cable is connected correctly.
Check
if
the MIDI
OUT connector on the keyboard
is securely
connected
to
the MIDI
IN connector
on
the CR-80
.
The
volume
of the CR-80
does not
change even
if you
vary the strength
with which
you
play
the
keyboard.
Check if the M!DI
cable is connected correctly.
Check
if
the MIDI
OUT connector on the MIDI keyboard is
securely
connected to the MIDI IN
connector
on the CR-80.
Determine If
you are
playing beyond
the control range.
If
you play
outside the
control
range
{
Higher than F#3)
on the
keyboard, the volume
of the CR-80
will not change
(Page
36).
Check if
Sync mode is
sel to
"EXT".
If
you set the Sync mode
to
"EXT"
,
the volume
of the CR-80 will
not change
{Page
37).
47