Roland CUBE 30 - Cautions for the Replacement of Damaged Power Supply Cord

12
Jul.2002
CAUTIONS FOR THE REPLACEMENT OF DAMAGED
POWER SUPPLY CORD
Please refer to the follwing “Notes” and confrim the Serial number when you replace the power supply cord.
Notes
1. The distance between terminal (included the part of winding the wire) is more than 6mm (refer to Fig.1).
fig.30ac1
2. Please wind the wire around the terminal 1.5 times before soldering wire to terminal.(refer to Fig.2)
fig.30ac2
3. When you remove the power supply cord from PS-1 BOARD, the dregs of a wire should not remain on a terminal.
100V ZP90420 -
117V,230V,230VE ZQ02580 -
240VA ZP91180 -
6mm min
COMMON
HOT
PS-1 BOARD
POWER SUPPLY
CORD
WIRING COLOR
HOT COMMON
117V BLACK WHITE
230V BROWN BLUE
230VE BROWN BLUE
240V BROWN BLUE