16
Discover5
Dec, 2002
HOW T
O CALIBRATE THE PITCH BENDER BY SOFTWARE
Turn the power on by keeping the button TOP pressed. After a few seconds, the display visualizes:
Place the Bender lever at half-stroke and press the button FADE OUT/ IN. The display visualizes:
Place the Bender lever to the left and press the button FADE OUT/IN. The display visualizes:
Place the Bender lever to the right and press the button FADE OUT/IN.
If the calibration is successful, the instrument exit from test mode, resets and go back to the initial display.
HOW TO INITIALIZE THE INTERNAL SETTINGS BY SOFTWARE
Turn the power on by keeping the button COVER pressed. After a few seconds, the display visualizes:
If the initialization is successful, the instrument exits from test mode, resets and go back to the initial display.
---- FLASH PARAMETER LOAD -----
WAIT PLEASE
------ PITCH BENDER CALIBRATION -----
ALL RIGHT POSITION
Then Press Fade OUT/IN Key
------ PITCH BENDER CALIBRATION -----
ALL LEFT POSITION
Then Press Fade OUT/IN Key
------ PITCH BENDER CALIBRATION -----
CENTER POSITION
Then Press Fade OUT/IN Key
To Next Page
Loading...
