- 28 -
Audio Pad
When a USB flash drive is connected and recognized, you can press the [AUDIO PAD / SCALE TUNE] button to
switch to Audio Pad mode. The button LED lights up and the LCD will temporarily display “AudioPad”.
1. Audio Pad buttons are [C], [C#], [D], [D#], [E], [F], [F#], [G], [G#],
[A], [A#] and [B].
When the audio files on USB flash drive are recognized, the
corresponding button LED will turn on. Press one of the lit buttons
to play back the corresponding MP3/WAV file. During playback,
the selected button LED will blink. Press the corresponding button
again to stop the audio playing back.
2. Audio Pad file names
Audio Pad files on USB flash drive should be named as below:
“File name 1” to “File name 4” can be recognized, but “FILE NAME 1” has priority.
3. Audio Pad playback mode
You can set the playback mode for each audio pad button.
Press and hold one of the Audio Pad buttons to enter edit
mode. Then use the data dial or the [EXIT] + [<] / [>] buttons to
select “One Shot” mode or “Loop” mode.
Audio files that can be played:
MP3
32, 40, 48, 56, 64, 80, 96, 112, 128, 160, 192, 224, 256, 320 kbps,
VBR (Variable Bit Rate)
To Next Page
Loading...
