2
● Program Change
Status 2nd byte
CnH ppH
n = MIDI channel number: 0H-FH (ch.1-ch.16)
pp = Program number: 00H..40H (prog.1..prog.65)
Received program change message are assigned as follows.
prog. tone
----------------------------------------------------------------------------------------------
1 Grand Piano
2 Bright Piano
3 Stage Rhodes
4 E.Piano
5 Harpsichord
6 Organ Flute
7 Pipe Organ
8 Rotaly Organ
9 Strings
10 Choir
11 ---
12 Grand Piano + Stage Rhodes
13 Grand Piano + E.Piano
14 Grand Piano + Harpsichord
15 Grand Piano + Organ Flute
16 Grand Piano + Pipe Organ
17 Grand Piano + Rotaly Organ
18 Grand Piano + Strings
19 Grand Piano + Choir
20 Bright Piano + Stage Rhodes
21 Bright Piano + E.Piano
22 Bright Piano + Harpsichord
23 Bright Piano + Organ Flute
24 Bright Piano + Pipe Organ
25 Bright Piano + Rotaly Organ
26 Bright Piano + Strings
27 Bright Piano + Choir
28 ---
29 Stage Rhodes + Harpsichord
30 Stage Rhodes + Organ Flute
31 Stage Rhodes + Pipe Organ
32 Stage Rhodes + Rotaly Organ
33 Stage Rhodes + Strings
34 Stage Rhodes + Choir
35 E.Piano + Harpsichord
36 E.Piano + Organ Flute
37 E.Piano + Pipe Organ
38 E.Piano + Rotaly Organ
39 E.Piano + Strings
40 E.Piano + Choir
41 ---
42 Harpsichord + Pipe Organ
43 Harpsichord + Rotaly Organ
44 Harpsichord + Strings
45 Harpsichord + Choir
46 Organ Flute + Pipe Organ
47 Organ Flute + Rotaly Organ
48 Organ Flute + Strings
49 Organ Flute + Choir
50 ---
51 Pipe Organ + Strings
52 Pipe Organ + Choir
53 Rotaly Organ + Strings
54 Rotaly Organ + Choir
55 ---
56 Acoustic Bass | Grand Piano
57 Strings | Grand Piano
58 Vibraphone
59 Electric Bass | Stage Rhodes
60 Clavi
61 Strings | Harpsichord
62 Strings | Pipe Organ
63 Rotary Organ | Jazz Organ
64 Strings + Brass
65 Strings | Flute
*“A+B” means tones for dual, and “A|B” means tones for split.
* “---” and any program number other than those listed above are ignored.
* After a Program Change message is received, the sound will change beginning with the
next Note-on. Voices already sounding when the Program Change message was
received will not be affected.
■Channel Mode Messages
● Reset All Controllers (Controller number 121)
Status 2nd byte 3rd byte
BnH 79H 00H
n = MIDI channel number : 0H-FH (ch.1-ch.16)
*When this message is received, the following controllers will be set to their reset values.
Controller Reset value
Expression 127 (max)
Hold 1 0 (off)
Sostenuto 0 (off)
Soft 0 (off)
● Local Control (Controller number 122)
Status 2nd byte 3rd byte
BnH 7AH vvH
n=MIDI channel number: 0H - FH (ch.1 - ch.16)
vv=Value: 00H, 7FH (0, 127) 0=OFF 127=ON
● All Notes Off (Controller number 123)
Status 2nd byte 3rd byte
BnH 7BH 00H
n = MIDI channel number: 0H-FH (ch.1-ch.16)
*When All Notes Off is received, all notes on the corresponding channel will be turned
off. However if Hold 1 or Sostenuto is ON, the sound will be continued until these are
turned off.
● OMNI OFF (Controller number 124)
Status 2nd byte 3rd byte
BnH 7CH 00H
n = MIDI channel number: 0H-FH (ch.1-ch.16)
* The instrument will behave in the same way as it does when an “All Notes Off” message
is received. The mode will be OMNI OFF, POLY (Mode 3).
● OMNI ON (Controller number 125)
Status 2nd byte 3rd byte
BnH 7DH 00H
n = MIDI channel number: 0H-FH (ch.1-ch.16)
* The instrument will behave in the same way as it does when an “All Notes Off” message
is received. The mode will be OMNI ON, POLY (Mode 1).
● MONO (Controller number 126)
Status 2nd byte 3rd byte
BnH 7EH mmH
n = MIDI channel number: 0H-FH (ch.1-ch.16)
mm = mono number: 00H-10H (0-16)
* The same processing will be carried out as when All Notes Off is received.
● POLY (Controller number 127)
Status 2nd byte 3rd byte
BnH 7FH 00H
n = MIDI channel number: 0H-FH (ch.1-ch.16)
* The same processing will be carried out as when All Notes Off is received.
To Next Page
Loading...
