Roland fp-30 Midi Implementation

MIDI Implementation
22
70112: Overdrive2
This is an overdrive that provides heavy distortion.
No Parameter Value Description
1 Drive 0–127 0–127
Degree of distortion
Also changes the volume.
2 Tone 0–127 0–127
Sound quality of the
Overdrive eect
3 Amp Sw 0 –1 O, On
Turns the Amp Simulator on/
o.
4 Amp Type #1 0–3
Small,
Built-In,
2-Stack,
3-Stack
Type of guitar amp
Small: small amp
Built-In: single-unit type amp
2-Stack: large double stack
amp
3-Stack: large triple stack amp
5 Low Gain 0–30 -15–+15 dB Gain of the low range
6 High Gain 0–30 -15–+15 dB Gain of the high range
7 Pan 0 –127 L64–63R
Stereo location of the output
sound
8 Level #2 0–127 0–127 Output Level
70113: Distortion2
This is a distortion eect that provides heavy distortion. The parameters are the
same as for “Overdrive2.”
70107: Speaker Simulator
Simulates the speaker type and mic settings used to record the speaker sound.
No Parameter Value Description
1
Speaker Type
#1
0–15
(See the
table.)
Type of speaker
2 Mic Setting 0–2 1, 2, 3
Adjusts the location of the
mic that is recording the
sound of the speaker.
This can be adjusted in three
steps, with the mic becoming
more distant in the order of 1,
2, and 3.
3 Mic Level 0–127 0–127 Volume of the microphone
4 Direct Level 0–127 0 –127 Volume of the direct sound
5 Level #2 0–127 0–127 Output Level
6 Specications of each Speaker Type
The speaker column indicates the diameter of each speaker unit (in inches) and the
number of units.
Type Cabinet Speaker Microphone
Small 1 Small open-back enclosure 10 Dynamic
Small 2 Small open-back enclosure 10 Dynamic
Middle Open back enclosure 12 x 1 Dynamic
JC-120 Open back enclosure 12 x 2 Dynamic
Built-In 1 Open back enclosure 12 x 2 Dynamic
Built-In 2 Open back enclosure 12 x 2 Condenser
Built-In 3 Open back enclosure 12 x 2 Condenser
Built-In 4 Open back enclosure 12 x 2 Condenser
Built-In 5 Open back enclosure 12 x 2 Condenser
BG Stack 1 Sealed enclosure 12 x 2 Condenser
BG Stack 2 Large sealed enclosure 12 x 2 Condenser
MS Stack 1 Large sealed enclosure 12 x 4 Condenser
MS Stack 2 Large sealed enclosure 12 x 4 Condenser
Metal Stack Large double stack 12 x 4 Condenser
2-Stack Large double stack 12 x 4 Condenser
3-Stack Large triple stack 12 x 4 Condenser
70114: Guitar Amp Simulator
This is an eect that simulates the sound of a guitar amplier.
No Parameter Value Description
1 Pre Amp Sw 0–1 O, On Turns the amp switch on/o.
2
Pre Amp
Type #1
0–13
JC-120, Clean
Twin, MATCH
Drive, BG
Lead,
MS1959I,
MS1959II,
MS1959I+II,
SLDN Lead,
Metal 5150,
Metal Lead,
OD-1,
OD-2 Turbo,
Distortion,
Fuzz
Type of guitar amp
3
Pre Amp
Volume
0–127 0–127
Volume and amount of
distortion of the amp
4
Pre Amp
Master
0–127 0–127 Volume of the entire pre-amp
5 Pre Amp Gain 0–2
Low, Middle,
High
Amount of pre-amp distortion
6 Pre Amp Bass 0 –127
0–127
Tone of the bass/mid/treble
frequency range
Middle cannot be set if
“MATCH Drive” is selected as
the Pre Amp Type.
7
Pre Amp
Middle
0–127
8
Pre Amp
Treble
0–127
9
Pre Amp
Presence
0–127
0–127
(MATCH
Drive: -127–0)
Tone for the ultra-high
frequency range
10
Pre Amp
Bright
0–1 O, On
Turning this “On” produces a
sharper and brighter sound.
This parameter applies to the
“JC-120,” “Clean Twin,” and
“BG Lead” Pre Amp Types.
11 Speaker Sw 0–1 O, On
Determines whether the
signal passes through the
speaker (On), or not (O).
12
Speaker Type
#2
0–15
(See the
table.)
Type of speaker
13 Mic Setting 0–2 1, 2, 3
Adjusts the location of the
mic that’s capturing the
sound of the speaker.
This can be adjusted in three
steps, from 1 to 3, with the
mic becoming more distant as
the value increases.
14 Mic Level 0 –127 0–127 Volume of the microphone
15 Direct Level 0–127 0–127 Volume of the direct sound
16 Pan 0 –127 L64–63R Stereo location of the output
17 Level 0–127 0–127 Output level

Roland fp-30 Specifications

General

Certification	FCC, CE
Sound effects	Ambience, Brilliance
Tones quantity	35
Pedals quantity	1
RMS rated power	24 W
Speaker diameter	120 mm
Number of speakers	2
Metronome tempo range	20 - 250 bpm
Metronome beats per bar	0, 2, 3, 4, 5
Maximum polyphony (notes)	128
Bluetooth version	4.0
USB connector type	USB Type-A, USB Type-B
Headphone connectivity	3.5 mm
AC input voltage	100 - 240 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (max)	22 W
Power consumption (min)	3 W
Built-in display	No
Country of origin	Malaysia
Tuning frequency	415.3 - 466.2 Hz
Demo songs quantity	30
Transposition range	-6 - 5 octave(s)
Sound pressure level	120 dB
Product color	White
Keys quantity	88 keys
Number of keyboard sensitivity levels	5

Weight and Dimensions

Depth	284 mm
Width	1300 mm
Height	150 mm
Weight	14100 g