Roland Gaia SH-01 - Powering the Unit On and Off; Procedure for Turning the Unit Power On; Procedure for Turning the Unit Power Off

15
Sound E ect (PRESET PATCH: H-5)
1
2 3
6
4
8 10
9 11
5 7
Here’s how to create a sound e ect that might be appropriate
for a spaceship taking o .
* These settings may produce a sudden, loud sound. Turn the knobs slowly to avoid damaging your hearing
or your speakers.
1
Press the [CANCEL/SHIFT] button and [WRITE] button to recall the initialized sound.
The sawtooth wave is selected.
2
Press the OSC [WAVE] button to select NOISE.
3
Turn the FILTER [CUTOFF] knob all the way to the left (MIN).
You will no longer hear sound.
4
Set the FILTER [RESONANCE] knob to the 9 o’clock position.
5
Set the FILTER ENV [A] slider to 50%, the [D] slider to 65%, and the [R] slider to 60%.
Lower the [S] slider all the way to the bottom.
6
Slowly raise the FILTER ENV [ENV DEPTH] slider to the maximum position.
7
Set the AMP ENV [A] slider to 55%, the [D] slider to 65%, and the [R] slider to 70%.
Lower the [S] slider all the way to the bottom.
8
Press the [PANNING DELAY] button so it’s lit.
9
Set the EFFECTS [CONTROL 1] knob to the 11 o’clock position to add some spaciousness.
10
Press the [REVERB] button so it’s lit.
11
Set the EFFECTS [CONTROL 1] knob to the 12 o’clock position to add reverb.
This sound e ect is similar to the sound in chapter 5 “How to Make a Sound” of the
DVD.