Roland Gaia SH-01 - Important Operational Notes; Power Supply and Connection Precautions

6
Create a Sound!
2
STEP
Create a Bass Sound
Use the [CUTOFF] Knob to Fatten the Sound!
Moving the [CUTOFF] knob will make the sound fatter or brighter. Once you’ve
familiarized yourself with its function, try moving the [CUTOFF] knob between
10 o’clock and one o’clock while you raise and lower the LFO [FILTER DEPTH]
slider. It’s e ective to do this in sync with the tempo.
1. Call up the “PRESET B-1” patch.
Press the [PRESET
PATCH] button
Press the [1] button
Press the [BANK] button and
then press the [2] (B) button
2. Press the [KEY HOLD] button so it’s blinking.
3. Press the second C key from the bottom.
You’ll hear an arpeggiated techno bass.
4. Turn the FILTER [RESONANCE] knob to the
maximum position.
5. Slowly turn the FILTER [CUTOFF] knob from
the maximum position down to the minimum.
It’s e ective to make this change in sync with the tempo.
6. Set the [RESONANCE] knob at 10 o’clock, and
the [CUTOFF] knob at 12 o’clock.
7. In sync with the tempo, raise the LFO [FILTER DEPTH]
slider, and then bring it back to the center.
For the LFO DEPTH, the center is 0.
A NOTE OF
ADVICE
Use the [CUTOFF] Knob to Fatten the Sound!
Moving the [CUTOFF] knob will make the sound fatter or brighter. Once you’ve
familiarized yourself with its function, try moving the [CUTOFF] knob between
10 o’clock and one o’clock while you raise and lower the LFO [FILTER DEPTH]
slider. It’s e ective to do this in sync with the tempo.
ADVICE
ADVICE