Roland GP609 - Advanced Operation; Memory Initialization and Factory Reset

19
Advanced Operation
˙
Convenient Functions
Initializing the Memory (Format Media)
Here’s how to erase all of the les that you saved in internal memory or
on a USB ash drive (sold separately).
NOTE
5 When you initialize, all registrations or data that you saved in
internal memory or on a USB ash drive are lost.
5 If you want settings other than the internal memory settings
to be returned to their factory-set state, execute a Factory
Reset (p. 19).
1. If you want to initialize a USB ash drive, connect the USB
ash drive to the USB Memory port (p. 7).
2. Press the [Ambience] button and [Brilliance] button
simultaneously.
3. Use the [K] [J] buttons to select “Format Media,” and then
press the [s] (Enter) button.
The Format Media screen appears.
-
If you decide to cancel, press the [u] (Exit) button.
4. Use the [–] [+] buttons to select the media (Internal
Memory or USB Memory) that you want to format.
5. Press the [s] (Enter) button.
A conrmation message appears.
If you decide to cancel, press the [u] (Exit) button.
6. Use the cursor [J] (right) button to select “Yes,” and then
press the [s] (Enter) button.
The memory is formatted.
NOTE
Never disconnect the USB ash drive or turn o the power while
the screen indicates “Executing...”
7. Simultaneously press the [Ambience] button and
[Brilliance] button to exit Function mode.
Restoring the Factory Settings (Factory Reset)
Here’s how to restore all registrations and internally saved settings to
the factory-set condition. This function is called “Factory Reset.”
NOTE
Factory Reset erases all settings that you have stored, and returns
them to the factory-set condition.
MEMO
Executing this function does not erase the data in internal
memory or on a USB ash drive (sold separately). If you want to
erase all the data from internal memory or from a USB ash drive,
refer to “Initializing the Memory (Format Media)” (p. 19).
1. Press the [Ambience] button and [Brilliance] button
simultaneously.
2. Use the [K] [J] buttons to select “Factory Reset,” and then
press the [s] (Enter) button.
A conrmation message appears.
If you decide to cancel, press the [u] (Exit) button.
3. Use the cursor [J] (right) button to select “Yes,” and then
press the [s] (Enter) button.
The memory is reset to its factory values.
NOTE
Never turn o the power while the screen indicates “Executing...”
4. Turn the power o, then on again (p. 4).