Roland GR-55 Training Guide

Roland GR-55 Training Guide
STEP THREE: Show Combination Sounds
1. Select OTHER 10-2 Sequence Clean.
2. Play some chords.
3. Press CTL to hold the synth sounds.
4. Play guitar over the synth sounds,
5. Adjust the EXP pedal to change the speed of the pattern and the guitar
tremolo.
6. Select USER 07-2 Syn Str. Pdl Reso
7. Play some chords.
8. Rock the EXP pedal to activate the filter.
9. Press CTL to remove the guitar from the sound.
STEP FOUR: Show the Looper
1. Select OTHER 27-2 Shanai+Rhythm
2. Press Pedal 3 and CTL simultaneously to arm the Looper. The CTL pedal
LED will flash.
3. When you are ready, press CTL and play a simple chord pattern. The LED
will flash quickly.
4. Press CTL to end the loop recording and play back the loop.
5. While the loop is playing, select OTHER 26-1 AggroClav.
6. Press CTL to record this sound over the first loop.
7. Press CTL to continue playing over the loop.
8. Press CTL twice to stop recording.
9. Press Pedal 3 and CTL to exit loop recording.

Roland GR-55 Specifications

General

Bit rate	24 bit
Best uses	Guitar
Sample rate	44.1 kHz
Product type	Footswitch/controller
Sound effects	Chorus, Delay, Modulation, Reverberation
Delay effects quantity	7
Number of footswitches	-
Sound effects quantity	93
Chorus effects quantity	4
Reverberation effects quantity	5
Modulation (MOD) effects quantity	14
Display type	LCD
Power source type	AC

Weight and Dimensions

Depth	244 mm
Width	405 mm
Height	78 mm
Weight	3300 g