Roland GR-55 Training Guide

Roland GR-55 Training Guide
How to Use the Looper
1. Press PEDAL 3 and the CTL PEDAL simultaneously. The CTL LED will
flash, indicating standby (record-ready) mode.
2. Press CTL to start to recording. The LED will flash quickly to indicate
recording mode.
3. Press CTL to end recording and start playback. The LED will stay on.
4. Press CTL to overdub. The LED will flash quickly. To erase or stop
playback, press CTL twice quickly. The LED will flash indicating standby
mode.
5. Press PEDAL 3 and CTL simultaneously to exit the Looper.
6. NOTE: the GR-55’s looper can record for a total of 20 seconds.
4. FIVE THINGS TO KNOW and SHOW
1. Revolutionary guitar processor combines advanced PCM synthesis and
COSM modeling to create virtually any sound
2. Four simultaneous tone types: two PCM synth sounds, plus COSM
modeling sounds plus “normal” guitar input sound
3. EZ EDIT plus full programmability
4. MIDI out and USB MIDI and audio out for direct connection to other
synths, DAWS, computers, etc.
5. Second USB port for backup, data transfer, and audio playback via flash
drive
5. ACCESSORIES
1. Roland FC-300 MIDI Control Pedal
2. BOSS Bag-S2 Carrying bag
3. Roland RH-5, RH-200 or other headphones
4. Instrument cables

Roland GR-55 Specifications

General

Bit rate	24 bit
Best uses	Guitar
Sample rate	44.1 kHz
Product type	Footswitch/controller
Sound effects	Chorus, Delay, Modulation, Reverberation
Delay effects quantity	7
Number of footswitches	-
Sound effects quantity	93
Chorus effects quantity	4
Reverberation effects quantity	5
Modulation (MOD) effects quantity	14
Display type	LCD
Power source type	AC

Weight and Dimensions

Depth	244 mm
Width	405 mm
Height	78 mm
Weight	3300 g