Roland GW-7 - Punch-In;Out and Additional Recording

23
GW-7
1. Please verify that Output-L and Headphones from left side sign wave
output.
2. Press the [ENTER] button to proceed to the R-ch test.
* According to the setting of the computer, when automatically advancing from
“4. USB Test” it is likely not to sound out. For this case, please press the
[SHIFT] button.
(R-ch Test)
3. Please verify that Output-R and Headphones from right side triangle
wave output.
4. Press the [ENTER] button to proceed to the L/R-ch test.
(L/R-ch Test)
fig.lcd-t10-lr.eps
5. Please verify that Output-L and Headphones from left side sign wave
output and Output-R and Headphones from right side triangle wave
output.
6. Press the [ENTER] button to proceed to the L/R-ch test.
6.LCD Test
fig.lcd-t11-whole.eps
1. Verify that all pixels of the LCD lit.
2. Press the [ENTER] button to proceed to the All LCD Pixels Unlit test.
fig.lcd-t12-noth.eps
3. Verify that all pixels of the LCD are unlit.
4. Press the [ENTER] button to proceed to the LCD Contrast Test.
(LCD Contrast Test)
fig.lcd-t13-lcd20.eps
5. Verify that you can adjust the contrast by moving the "VALUE" encoder.
The contrast value (from 1 to 40) will be displayed in the LCD.
6. Press the [ENTER] button to proceed to the next test.
7. A/D Test 1 (Bender, Modulation)
Verify that bender and modulation operate correctly.
Make sure that the bender is not being touched when you enter this test. (The
A/D value at the moment you enter the test is read as the center voltage.)
fig.lcd-t14-bend.eps
1. Move the bender all the way to the left; if a value of “-128” is reached, a
click will sound.
2. Move the bender all the way to the right; if a value of “127” is reached, a
click will sound.
3. When left and right movements are completed, the display will indicate
“OK”.
4. Move the modulation lever fully away from yourself; if a value of “127” is
reached, a click will sound.